enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  3. Cured-in-place pipe - Wikipedia

    en.wikipedia.org/wiki/Cured-in-place_pipe

    It is a jointless, seamless pipe lining within an existing pipe. As one of the most widely used rehabilitation methods, CIPP has applications in sewer, water, gas, chemical and district heating pipelines ranging in diameter from 0.1 to 2.8 meters (2–110 inches).

  4. Plastic pipework - Wikipedia

    en.wikipedia.org/wiki/Plastic_pipework

    Acrylonitrile butadiene styrene (ABS) is used for the conveyance of potable water, slurries and chemicals. Most commonly used for DWV (drain-waste-vent) applications. It has a wide temperature range, from -40 °C to +60 °C. ABS is a thermoplastic material and was originally developed in the early 1950s for use in oil fields and the chemical ...

  5. Orangeburg pipe - Wikipedia

    en.wikipedia.org/wiki/Orangeburg_pipe

    [1] [2] It was used from the 1860s through the 1970s, when it was replaced by PVC pipe for water supply and ABS pipe for drain-waste-vent (DWV) applications. The name comes from Orangeburg, New York, the town in which most Orangeburg pipe was manufactured, largely by the Fiber Conduit Company. It changed its name to the Orangeburg Manufacturing ...

  6. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

  7. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    For example, DN20 is the size for copper pipe with an outside diameter of 19.05 mm or 3 ⁄ 4 inch. While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a ...

  8. Barcol hardness test - Wikipedia

    en.wikipedia.org/wiki/Barcol_hardness_test

    The governing standard for the Barcol hardness test is ASTM D 2583. [4] Barcol hardness is measured on a scale from 0 to 100 with the typical range being between 50B and 90B. A measurement of 60B is roughly equivalent to a Shore hardness of 80D or a Rockwell hardness M100.

  9. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    Copper tubing is available in four wall thicknesses: type DWV (thinnest wall; only allowed as drain pipe per UPC), type 'M' (thin; typically only allowed as drain pipe by IPC code), type 'L' (thicker, standard duty for water lines and water service), and type 'K' (thickest, typically used underground between the main and the meter).