enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

  3. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]

  4. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    A characteristic of the eastern school is close studding which is a half-timbering style of many studs spaced about the width of the studs apart (for example six-inch studs spaced six inches apart) until the middle of the 16th century and sometimes wider spacing after that time. Close studding was an elite style found mostly on expensive buildings.

  5. Blocking (construction) - Wikipedia

    en.wikipedia.org/wiki/Blocking_(construction)

    Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.

  6. Frame and panel - Wikipedia

    en.wikipedia.org/wiki/Frame_and_panel

    Frame and panel construction at its most basic consists of five members: the panel and the four members which make up the frame. The vertical members of the frame are called stiles while the horizontal members are known as rails. A basic frame and panel item consists of a top rail, a bottom rail, two stiles, and a panel.

  7. This Hack Will Ensure You ALWAYS Hit A Stud - AOL

    www.aol.com/lifestyle/hack-ensure-always-hit...

    The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.

  8. Joist - Wikipedia

    en.wikipedia.org/wiki/Joist

    A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).

  9. Pole building framing - Wikipedia

    en.wikipedia.org/wiki/Pole_building_framing

    The structural frame of a pole building is made of tree trunks, utility poles, engineered lumber or chemically pressure-treated squared timbers which may be buried in the ground or anchored to a concrete slab. Generally the posts are evenly spaced 8 to 12 feet (2.4 to 3.7 m) apart except to allow for doors.