Search results
Results from the WOW.Com Content Network
Maximum distortion energy theory, also known as maximum distortion energy theory of failure or von Mises–Hencky theory. This theory postulates that failure will occur when the distortion energy per unit volume due to the applied stresses in a part equals the distortion energy per unit volume at the yield point in uniaxial testing.
Limit load is the maximum load that a structure can safely carry. It's the load at which the structure is in a state of incipient plastic collapse. As the load on the structure increases, the displacements increases linearly in the elastic range until the load attains the yield value.
The strongest possible size effect occurs for specimens with similar deep notches (Fig. 4b), or for structures in which a large crack, similar for different sizes, forms stably before the maximum load is reached. Because the location of fracture initiation is predetermined to occur at the crack tip and thus cannot sample the random strengths of ...
There are two definitions for the factor of safety (FoS): The ratio of a structure's absolute strength (structural capability) to actual applied load; this is a measure of the reliability of a particular design. This is a calculated value, and is sometimes referred to, for the sake of clarity, as a realized factor of safety.
Limit load can refer to: Limit load (aeronautics) , the maximum load factor during flight Limit load (physics) , maximum load that a structure can safely carry
The critical load is the greatest load that will not cause lateral deflection (buckling). For loads greater than the critical load, the column will deflect laterally. The critical load puts the column in a state of unstable equilibrium. A load beyond the critical load causes the column to fail by buckling. As the load is increased beyond the ...
In engineering, the ultimate load [1] is a statistical figure used in calculations, and should (hopefully) never actually occur.. Strength requirements are specified in terms of limit loads (the maximum loads to be expected in service) and ultimate loads (limit loads multiplied by prescribed factors of safety).
Representative curves of applied stress vs number of cycles for steel (showing an endurance limit) and aluminium (showing no such limit).. The fatigue limit or endurance limit is the stress level below which an infinite number of loading cycles can be applied to a material without causing fatigue failure. [1]