Search results
Results from the WOW.Com Content Network
The clutch in a manual-shift motorcycle transmission is typically an arrangement of plates stacked in alternating fashion, one geared on the inside to the engine and the next geared on the outside to the transmission input shaft. Whether wet (rotating in engine oil) or dry, the plates are squeezed together by springs, causing friction build up ...
A motorcycle fork is the portion of a motorcycle that holds the front wheel and allows one to steer. For handling, the front fork is the most critical part of a motorcycle. The combination of rake and trail determines how stable the motorcycle is. The 'fork' on a motorcycle consists of multiple components.
A chainsaw's clutch. The chain wraps around a sprocket behind the clutch that turns with the outer drum. The input of the clutch is connected to the engine crankshaft while the output may drive a shaft, chain, or belt. As engine revolutions per minute increase, weighted arms in the clutch swing outward and force the clutch to engage. The most ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 31 December 2024. Mechanical device that connects and disconnects two rotating shafts or other moving parts For other uses, see Clutch (disambiguation). Friction disk for a dry clutch A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. The clutch's ...
Slipper clutches can also prevent a catastrophic rear wheel lockup in case of engine seizure. Generally, the amount of force needed to disengage the clutch is adjustable to suit the application. Slipper clutches have also been used to a lesser extent on automobiles, primarily those powered by motorcycle engines.
On a motorcycle equipped with a conventional hand clutch and foot shifter, the rider places the left foot on the ground when stopped and holds the motorcycle in place with pressure on the rear brake pedal with the right foot, while engaging the clutch with the left hand. On a motorcycle equipped with a suicide clutch, the clutch is held in with ...
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
The clutch pedal controls the pressure plate (clutch engaged – the clutch pedal is not being pressed) or not connected to the engine (clutch disengaged – the clutch pedal is being pressed down). When the engine is running and the clutch is engaged (i.e., clutch pedal up), the flywheel spins the clutch pressure plate and hence the transmission.