Search results
Results from the WOW.Com Content Network
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Although close studding is defined by the distance between the vertical timbers, the spacing used is variable, up to a maximum of around 2 feet (600 mm). [2] Studs can either span the full height of the storey or be divided by a middle (or intermediate) rail. To give the frame stability, some form of diagonal bracing is required. [2]
All of these tasks require drilling into a stud in the wall. The stud is simply a vertical two-by-four beam in the wall for structural support. ... outlet the stud is on, and use that 16-inch stud ...
Steel studs are gaining popularity as a non-combustible alternative, especially for non load-bearing walls, and are required in some firewalls. In New Zealand, the required lumber size and spacing of wall studs are determined using NZS 3604 Timber-framed buildings table 8.2 for loadbearing walls and table 8.4 for non-loadbearing walls. [4]
The Franklin County Sheriff's Office continues to look for a gunman who fatally shot a man last Friday night in the parking lot of a Home Depot store in Prairie Township.
Spades is all about bids, blinds and bags. Play Spades for free on Games.com alone or with a friend in this four player trick taking classic.
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]