enow.com Web Search

  1. Ads

    related to: tv rf switch for antenna

Search results

  1. Results from the WOW.Com Content Network
  2. Analog passthrough - Wikipedia

    en.wikipedia.org/wiki/Analog_passthrough

    Before digital television, passthrough originally existed in VCRs (and later PVRs and DVDRs) that connected to a TV set using RF connector, allowing the TV antenna or cable TV signal to be switched to pass through the VCR, or have VCR output added as an extra channel.

  3. RF modulator - Wikipedia

    en.wikipedia.org/wiki/RF_modulator

    The motherboard of an early microcomputer, the Microtan 65, showing the silver-cased ASTEC 1111EM36 UHF TV modulator at top left. Prior to the introduction of specialised video connector standards such as SCART, TVs were designed to only accept signals through the aerial connector: signals originate at a TV station, are transmitted over the air, and are then received by an antenna and ...

  4. RF switch - Wikipedia

    en.wikipedia.org/wiki/RF_switch

    An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...

  5. 8VSB - Wikipedia

    en.wikipedia.org/wiki/8VSB

    Unlike the previous digital TV transition which was mandated by the FCC, the "transition" to ATSC 3.0 will be completely voluntary. Additionally, the FCC has required that broadcasters who decided to make the switch to ATSC 3.0 continue to make their main channel available through a simulcast agreement with another in-market station (with a ...

  6. Digital television adapter - Wikipedia

    en.wikipedia.org/wiki/Digital_television_adapter

    A RF/antenna output, if present on a converter box, is usually just a passthrough ("LOOP OUT" which does not provide the box's output signal, but only provides the raw antenna input signal to watch analog channels via a TV set's tuner if analog broadcasts have not ended yet or to connect another capable device to the same antenna feed) because ...

  7. Low-noise block downconverter - Wikipedia

    en.wikipedia.org/wiki/Low-noise_block_downconverter

    Astra type LNBFs incorporate two probes in the waveguide, at right angles to one another so that, once the LNB has been skewed in its mount to match the local polarization angle, one probe collects horizontal signals and the other vertical, and an electronic switch (controlled by the voltage of the LNB's power supply from the receiver: 13 V for ...

  1. Ads

    related to: tv rf switch for antenna