enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hurst Performance - Wikipedia

   en.wikipedia.org/wiki/Hurst_Performance

   Hurst Performance was originally named Hurst-Campbell. The company was established in 1958 as an auto repair shop when George Hurst and Bill Campbell were both young men. The original shop was located on Glenside Ave. in Glenside, Pennsylvania. They later moved to a large building on the corner of Street Road and Jacksonville Road in Warminster ...

3. Ford Boss 302 engine - Wikipedia

   en.wikipedia.org/wiki/Ford_Boss_302_engine

   The Ford Boss 302 (formally the "302 H.O.") is a high-performance "small block" 302 cu in (4.9 L) V8 engine manufactured by Ford Motor Company.The original version of this engine was used in the 1969 and 1970 Boss 302 Mustangs and Cougar Eliminators and was constructed by attaching heads designed for the planned 351 Cleveland (which debuted the following year) to a Ford small block. [1]

4. List of auto parts - Wikipedia

   en.wikipedia.org/wiki/List_of_auto_parts

   This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines ) and electric vehicles ; the list is not exhaustive.

5. Boss 302 Mustang - Wikipedia

   en.wikipedia.org/wiki/Boss_302_Mustang

   The Mustang Boss 302 is a high-performance 302 cu in (4.9 L) H.O. V8-powered variant of the Ford Mustang originally produced by Ford in 1969 and 1970. Developed to meet homologation requirements to compete in Trans Am racing, it was Ford's response to the success of the Chevrolet Camaro Z/28 in the 5 L (305.1 cu in) and under SCCA series since 1967.

6. Ford small block engine - Wikipedia

   en.wikipedia.org/wiki/Ford_small_block_engine

   For 1968 only, a special high-performance Shelby-modified version of the 302 was offered by Ford in the Shelby GT350. [11] The main features included: an angled, high-rise aluminum or iron intake manifold, a larger Holley four-barrel carburetor, and bigger valves of 1.78 in (45 mm) intake and 1.6 in (41 mm) exhaust.

7. Main bearing - Wikipedia

   en.wikipedia.org/wiki/Main_bearing

   The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).