Search results
Results from the WOW.Com Content Network
[9] [14] The 32 H&R cartridge was dimensionally longer than many other contemporary .32 caliber pistol cartridges, including the .32 S&W, .32 Short Colt, and .32 Long Colt, and was loaded with a stout 15 grains of black powder over an 88 grain projectile (compared to the 10 grain charge of the contemporary .32 S&W, or the 13 grain charge of the ...
An H&R Handy-Gun. The H&R Handy-Gun is a single-shot, breech-loading handgun produced from 1921 to 1934 by Harrington & Richardson. Two principal variants were produced: one with a rifled barrel and one smooth-bore. [1] [2] The rifled-barrel variant was produced from 1930 to 1934 and it featured a 12 1 ⁄ 4" barrel.
While a flintlock, for example, is immediately ready to reload once it has been fired, adopting brass cartridge cases brought in the problems of extraction and ejection. The mechanism of a modern gun must not only load and fire the piece but also provide a method of removing the spent case, which might require just as many added moving parts.
This is a table of selected pistol/submachine gun and rifle/machine gun cartridges by common name. Data values are the highest found for the cartridge, and might not occur in the same load (e.g. the highest muzzle energy might not be in the same load as the highest muzzle velocity, since the bullet weights can differ between loads).
Second, the gun's striker-firing mechanism is locked in place by an extension bar linked to the trigger; the striker cannot move unless the trigger is depressed. Third, as with most pistols, a firing pin block actuated by the same extension bar prevents the pin coming into contact with the primer unless the trigger is pulled to clear the block.
The H&R design loaded the dart from the XM144 into their own cartridge design. The H&R design was the most advanced. It mounted the dart between three plastic sabots in a triangular plastic cartridge. When fired, the sabots were discarded early in small "sub-barrels" while the dart continued down the main barrel.
.32 H&R Magnum.32-20 Winchester.327 Federal Magnum 9×19mm Parabellum.357 Magnum.357 Remington Maximum (Discontinued) 10mm Auto.38-40 Winchester.41 Magnum.44 Special.44-40 WCF.44 Magnum (Super Blackhawk only).45 ACP.45 Colt.38 Special
Close-up of an IOF 32 break-action revolver. The first break-action revolver was patented in France and Britain at the end of December in 1858 by Devisme. [1] A substantial hinge pin joins the two parts of the rifle or shotgun; the stock with its firing mechanism and the fore-piece and barrel, which hold the round to be fired.