Search results
Results from the WOW.Com Content Network
The braking current decays, and after a delay of about 1.5 seconds the braking relay contactor opens again. At this point the motor can be restarted. In such a unit, there are typically two potentiometers, one to vary the braking torque from the firing circuit and the other to vary the timer. These settings are balanced so that braking torque ...
For the tests the vehicle brake for which the replacement linings are designed is installed in an inertia dynamometer instrumented for continuous recording of rotative speed, brake torque, brake line pressure, number of rotations after brake application, braking time, and brake rotor temperature. [1]
To do this, engineers use the formula: T = (J × ΔΩ) / t, where T = required braking torque (in N m), J = rotational inertia of system to be braked (in kg m2), ΔΩ = required change in rotational speed (in rad/s), and t = time during which the acceleration or deceleration must take place (in s).
In vector control, an AC induction or synchronous motor is controlled under all operating conditions like a separately excited DC motor. [21] That is, the AC motor behaves like a DC motor in which the field flux linkage and armature flux linkage created by the respective field and armature (or torque component) currents are orthogonally aligned such that, when torque is controlled, the field ...
EDC injection inline pump. The mechanical fly-weight governors of inline and distributor diesel fuel injection pumps used to control fuel delivery in diesel engines under a variety of engine loads and conditions could no longer deal with the ever-increasing demands for efficiency, emission control, power and fuel consumption. These demands are ...
Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors.This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.
Constant voltage operation above base frequency, and therefore with reduced V/Hz ratio, provides reduced torque and constant power capability. Regenerative AC drives are a type of AC drive which have the capacity to recover the braking energy of a load moving faster than the motor speed (an overhauling load) and return it to the power system.
Maximum brake torque (MBT) is the use of optimal ignition timing to take advantage of an internal combustion engine's maximum power and efficiency. There is always an optimal spark timing for all operating conditions of an engine. MBT is ideal at wide-open throttle (WOT), but not desirable when the engine is at idle.