Search results
Results from the WOW.Com Content Network
State of charge (SoC) quantifies the remaining capacity available in a battery at a given time and in relation to a given state of ageing. [1] It is usually expressed as percentage (0% = empty; 100% = full). An alternative form of the same measure is the depth of discharge , calculated as 1 − SoC (100% = empty; 0% = full).
Introduced 1898 as the first flashlight battery. Can be replaced with an AA cell or a C cell using a plastic sabot (size adaptor), with proportional loss of capacity. F: R25 (carbon‑zinc) LR25 (alkaline) 60: 10,500 (carbon‑zinc) 26,000 (alkaline) 1.5: 33 × 91 Four F cells are often found within 6-volt rectangular lantern batteries. N: Lady ...
Cell chemistry Also known as Electrode Rechargeable Commercialized Voltage Energy density Specific power Cost † Discharge efficiency Self-discharge rate Shelf life Anode Electrolyte Cathode Cutoff Nominal 100% SOC by mass by volume; year V V V MJ/kg (Wh/kg) MJ/L (Wh/L) W/kg Wh/$ ($/kWh) % %/month years Lead–acid: SLA VRLA PbAc ...
While the state of charge is usually expressed using percentage points (0 % = empty; 100 % = full), depth of discharge is either expressed using units of Ah (e.g. for a 50 Ah battery, 0 Ah is full and 50 Ah is empty) or percentage points (100 % is empty and 0 % is full). The capacity of a battery may also be higher than its nominal rating.
Charge carrier density, also known as carrier concentration, denotes the number of charge carriers per volume. In SI units, it is measured in m −3. As with any density, in principle it can depend on position. However, usually carrier concentration is given as a single number, and represents the average carrier density over the whole material.
The voltage and capacity of a C-size battery depends on the battery chemistry and discharge conditions. The nominal voltage is 1.5V. Alkaline C batteries have a storage capacity up to 8000 mAh while rechargeable NiMH C batteries can hold up to 6000 mAh. Zinc-carbon C batteries usually hold up to 3800 mAh.
These button cells generally follow the same compact design. The bottom portion of the cell is the cathode, which consists of a graphite infused silver oxide. A plastic membrane separates this from an anode of powdered zinc dissolved in an alkaline electrolyte. An insulating gasket keeps the two contacts apart, facilitating the discharge of the ...
The adenylate energy charge is an index used to measure the energy status of biological cells.. ATP or Mg-ATP is the principal molecule for storing and transferring energy in the cell : it is used for biosynthetic pathways, maintenance of transmembrane gradients, movement, cell division, etc...