enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Slide hammer - Wikipedia

   en.wikipedia.org/wiki/Slide_Hammer

   Diagram of the usage of a slide hammer A slide hammer attached to the inside of a rear wheel bearing Auto technician using a slide hammer to remove the hub on a car. A slide hammer is a tool that attaches to an object needing to be pulled and transmits an impact force to the object without striking the object itself.

3. Wheel hub assembly - Wikipedia

   en.wikipedia.org/wiki/Wheel_hub_assembly

   A roller bearing between the axle hub and axle shaft ensures easy rotation of the non-drive wheels. On the axle side, it is mounted to the holding bracket from the chassis; on the disc side, the wheel is mounted to the bolts of the WHA. When replacing, a wheel hub assembly should be torqued to the vehicle's specifications to prevent failure. [1]

4. Steering knuckle - Wikipedia

   en.wikipedia.org/wiki/Steering_knuckle

   The wheel and tire assembly attach to the hub or spindle of the knuckle where the tire/wheel rotates while being held in a stable plane of motion by the knuckle/suspension assembly. In the attached photograph of a double-wishbone suspension, the knuckle is shown attached to the upper control arm at the top and the lower control arm at the bottom.

5. Axle - Wikipedia

   en.wikipedia.org/wiki/Axle

   The semi-floating axle features only one bearing, while the full-floating assembly has bearings on both the inside and outside of the wheel hub. The other difference is axle removal. To remove the semi-floating axle, the wheel must be removed first; if such an axle breaks, the wheel is most likely to come off the vehicle.

6. Spindle (automobile) - Wikipedia

   en.wikipedia.org/wiki/Spindle_(automobile)

   Spindles or uprights - Jaguar left and Holden Gemini right The wheel spindle in the illustration is colored red. In an automobile, the wheel spindle, sometimes called simply the spindle, is the part of the suspension system that carries the hub for the wheel and attaches to the upper and lower control arms.

7. Kingpin (automotive part) - Wikipedia

   en.wikipedia.org/wiki/Kingpin_(automotive_part)

   The kingpins were now fixed to the axle ends and the hub carriers pivoted upon them. Most commonly the centre of the kingpin was fixed in the axle and the hub carrier was forked to fit over this, but some vehicles, including the Ford Model T illustrated, used a forked axle and a kingpin fixed into a single piece carrier.