Search results
Results from the WOW.Com Content Network
The LC500 GT500 car made its début at the 2017 Okayama GT 300km, [40] and claimed 14 race wins of the 24 overall entered races from 2017 until 2019 (26 with the Super GT/DTM crossover events). In 2020, with the introduction of the new Class One and the revival of the Supra nameplate, the Toyota GR Supra would take its place in the GT500 category.
[a] As the tire RPM at maximum speed is not the same as the engine RPM at that power, a transmission is used with a gear ratio to convert one to the other. [b] At even slightly lower speeds than maximum, the total drag on the vehicle is considerably less, and the engine needs to deliver this greatly reduced amount of power.
It is designed for service in vehicles up to 4000 lb (1814 kg) GVWR and in service was mated to a selection of final drive ratios 3.42:1, 3.73:1, or 3.91:1 depending on the carline. The 5L40-E had been designed for 1.8–3.6 L engines with a maximum of 250 ft·lbf (340 N·m) of torque.
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and3wweteeengine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
The designation of wide versus close ratio affected the lowest gear ratio; [7] for example, the four-speed Muncie transmissions offered in General Motors performance vehicles included the M20 "wide ratio" transmission, which had a first gear ratio of 2.52 or 2.56:1, while the M21 and M22 "close ratio" transmissions had a first gear ratio of 2. ...
Roto's disadvantage was the 2-3 range or 1-2 gear change because it is not only a huge ratio jump from 2-3 range or 1-2 shift from 2.93 to 1.56, but also there is no fluid slippage in the coupling because the coupling drains (four-tenths of a second) to engage or apply the front clutch and so the trans goes to full mechanical connection.
The 4HP is a 4-speed Automatic transmission family with a hydrodynamic Torque converter with an electronic hydraulic control for passenger cars from ZF Friedrichshafen AG.In selector level position "P", the output is locked mechanically.