enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Stopcock - Wikipedia

   en.wikipedia.org/wiki/Stopcock

   Example of symbol for a stop valve. A stopcock is a form of valve used to control the flow of a liquid or gas. The term is not precise and is applied to many different types of valve. The only consistent attribute is that the valve is designed to completely stop the flow when closed fully.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Valves stop (or regulate) the flow of liquids or gases. They are categorized by application, such as isolation, throttling, and non-return. Isolation valves temporarily disconnect part of a piping system to allow maintenance or repair, for example. Isolation valves are typically left in either a fully open or closed position.

4. Globe valve - Wikipedia

   en.wikipedia.org/wiki/Globe_valve

   Economical globe valves or stop valves with a similar mechanism used in plumbing often have a rubber washer at the bottom of the disc for the seating surface, so that rubber can be compressed against the seat to form a leak-tight seal when shut. Electrically automated 3/4" flanged globe valve

5. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   Choke valve, Butterfly valve used to limit air intake in internal combustion engine. (Not to be confused with choke valves used in industrial flow control, above.) Clapper valve: a type of check valve used in the Siamese fire appliance to allow only one hose to be connected instead of two (the clapper valve blocks the other side from leaking out)

6. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals).

7. Valve - Wikipedia

   en.wikipedia.org/wiki/Valve

   Schematic 3 way ball valve: L-shaped ball right, T-shaped left. Valves with three ports serve many different functions. A few of the possibilities are listed here. Three-way ball valves come with T- or L-shaped fluid passageways inside the rotor. The T valve might be used to permit connection of one inlet to either or both outlets or connection ...