Search results
Results from the WOW.Com Content Network
The elevation is the signed angle from the x-y reference plane to the radial line segment OP, where positive angles are designated as upward, towards the zenith reference. Elevation is 90 degrees (= π / 2 radians) minus inclination. Thus, if the inclination is 60 degrees (= π / 3 radians), then the elevation is 30 degrees ...
The horizontal coordinate system is a celestial coordinate system that uses the observer's local horizon as the fundamental plane to define two angles of a spherical coordinate system: altitude and azimuth. Therefore, the horizontal coordinate system is sometimes called the az/el system, [1] the alt/az system, or the alt-azimuth system, among
Geodetic latitude and geocentric latitude have different definitions. Geodetic latitude is defined as the angle between the equatorial plane and the surface normal at a point on the ellipsoid, whereas geocentric latitude is defined as the angle between the equatorial plane and a radial line connecting the centre of the ellipsoid to a point on the surface (see figure).
Pressure altitude is the elevation above a standard datum air-pressure plane (typically, 1013.25 millibars or 29.92" Hg). Pressure altitude is used to indicate "flight level" which is the standard for altitude reporting in the U.S. in Class A airspace (above roughly 18,000 feet).
The black dot shows the point with coordinates x = 2, y = 3, and z = 4, or (2, 3, 4). A Cartesian coordinate system for a three-dimensional space consists of an ordered triplet of lines (the axes ) that go through a common point (the origin ), and are pair-wise perpendicular; an orientation for each axis; and a single unit of length for all ...
In astronomy, the altitude in the horizontal coordinate system and the zenith angle are complementary angles, with the horizon perpendicular to the zenith. The astronomical meridian is also determined by the zenith, and is defined as a circle on the celestial sphere that passes through the zenith, nadir, and the celestial poles .
This is not always the case: the trivial equation x = x specifies the entire plane, and the equation x 2 + y 2 = 0 specifies only the single point (0, 0). In three dimensions, a single equation usually gives a surface , and a curve must be specified as the intersection of two surfaces (see below), or as a system of parametric equations . [ 18 ]
The angle of climb can be defined as the angle between a horizontal plane representing the Earth's surface, and the actual flight path followed by the aircraft during its ascent. The speed of an aircraft type at which the angle of climb is largest is called V X. It is always slower than V Y, the speed for the best rate of climb. As the latter ...