Search results
Results from the WOW.Com Content Network
An audio analyzer is a test and measurement instrument used to objectively quantify the audio performance of electronic and electro-acoustical devices. Audio quality metrics cover a wide variety of parameters, including level, gain, noise, harmonic and intermodulation distortion, frequency response, relative phase of signals, interchannel crosstalk, and more.
A system may have low distortion for a steady-state signal, but not on sudden transients. In amplifiers, this problem can be traced to power supplies in some instances, to insufficient high-frequency performance or to excessive negative feedback. Related measurements are slew rate and rise time. Distortion in transient response can be hard to ...
Electrostatic speakers can have lower harmonic distortion but suffer higher intermodulation distortion. 3% distortion residue corresponds to 1 or 2% total harmonic distortion. Professional monitors may maintain modest distortion up to around 110 dB SPL at 1 m, but almost all domestic speaker systems distort badly above 100 dB SPL.
Because measured audio distortion is higher in electromechanical components such as microphones, turntables, tonearms, phono cartridges, and loudspeakers than in purely electronic components such as preamplifiers and power amplifiers, objectivists generally do not accept that very subtle differences in the latter can have an appreciable effect ...
Audio engineers use dynamic range to describe the ratio of the amplitude of the loudest possible undistorted signal to the noise floor, say of a microphone or loudspeaker. [18] Dynamic range is therefore the signal-to-noise ratio (SNR) for the case where the signal is the loudest possible for the system. For example, if the ceiling of a device ...
Clipping can occur within a system as processing (e.g. an all-pass filter) can change the phase relationship between spectral components of a signal in such a way as to create excessive peak outputs. The excessive peaks may become clipped even though the system can play any simple sine wave signals of the same level without clipping.
In audio systems, lower distortion means that the components in a loudspeaker, amplifier or microphone or other equipment produce a more accurate reproduction of an audio recording. In radio communications, devices with lower THD tend to produce less unintentional interference with other electronic devices.
Presets stored settings for the amount of each kind of processing to be applied: automatic gain control, limiting, bass boost, etc. Presets cannot be added. The Volume Logic plug-in incorporated multi-band dynamics processing technology, solving common audio problems such as speaker distortion and volume shifting. [citation needed]