Search results
Results from the WOW.Com Content Network
A flame arrester during testing A flame arrester made for a 91 cm (36 inch) pipe weighing 10 tons. A flame arrester (also spelled arrestor), deflagration arrester, [1] or flame trap [2] is a device or form of construction that will allow free passage of a gas or gaseous mixture but will interrupt or prevent the passage of flame. It prevents the ...
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
An anti-tank mine with an anti-handling device fitted is almost guaranteed to detonate if it is lifted/overturned, because it is specifically designed to do so. Munitions fitted with anti-handling devices increase the difficulty and cost of post-conflict clearing operations, due to the inherent dangers of attempting to render them safe.
In the United States, plumbing codes usually provide strict limitations on how far a trap may be located from the nearest vent stack. When a vent cannot be provided, an air admittance valve may be used instead. These devices avoid negative pressure in the drain pipe by venting room air into the drain pipe (behind the trap).
The difficulty of casting complex spark arrestors encouraged fabrication of sheet metal chimneys for wood-burning locomotives. [5] Fifty-seven of over one thousand locomotive spark arrestors patented in the United States, 1857. Early spark arrestors were simply iron wire screens installed within the stack. However, the screen reduced the rate ...
If the mixture is ignited and the flame begins to travel back through the piping, the arrester will prohibit the flame from moving back to the gas source. Most detonation flame arrester applications are in systems which collect gases emitted by liquids and solids. These systems, commonly used in many industries, may be called vapor control systems.
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.