Search results
Results from the WOW.Com Content Network
A RAID 0 array of n drives provides data read and write transfer rates up to n times as high as the individual drive rates, but with no data redundancy. As a result, RAID 0 is primarily used in applications that require high performance and are able to tolerate lower reliability, such as in scientific computing [5] or gaming.
RAID (/ r eɪ d /; redundant array of inexpensive disks or redundant array of independent disks) [1] [2] is a data storage virtualization technology that combines multiple physical data storage components into one or more logical units for the purposes of data redundancy, performance improvement, or both.
Nested RAID levels, also known as hybrid RAID, combine two or more of the standard RAID levels (where "RAID" stands for "redundant array of independent disks" or "redundant array of inexpensive disks") to gain performance, additional redundancy or both, as a result of combining properties of different standard RAID layouts. [1] [2] Nested RAID ...
[1] [2] Data redundancy can also be used as a measure against silent data corruption; for example, file systems such as Btrfs and ZFS use data and metadata checksumming in combination with copies of stored data to detect silent data corruption and repair its effects. [3]
RAID In some RAID configurations, such as RAID 0, failure of a single member drive of the RAID array causes all stored data to be lost. In other RAID configurations, such as a RAID 5 that contains distributed parity and provides redundancy, if one member drive fails the data can be restored using the other drives in the array. LVM2
In a non-RAID application, it may be important for a disk drive to go to great lengths to successfully read a problematic storage block, even if it takes several seconds. In an appropriately configured RAID array, a single bad block on a single drive can be recovered completely via the redundancy encoded across the RAID set.
Around 1997, with the introduction of ATAPI-4 (and thus Ultra-DMA-Mode, which enabled fast data transfers with less CPU utilization) the first ATA RAID controllers were introduced as PCI expansion cards. Those RAID systems made their way to the consumer market, for users wanting the fault-tolerance of RAID without investing in expensive SCSI ...
There are five different RAID-Z modes: RAID-Z0 (similar to RAID 0, offers no redundancy), RAID-Z1 (similar to RAID 5, allows one disk to fail), RAID-Z2 (similar to RAID 6, allows two disks to fail), RAID-Z3 (a RAID 7 [a] configuration, allows three disks to fail), and mirror (similar to RAID 1, allows all but one of the disks to fail). [22]