enow.com Web Search

  1. Ads

    related to: temperature controller with ssr output

Search results

  1. Results from the WOW.Com Content Network
  2. Solid-state relay - Wikipedia

    en.wikipedia.org/wiki/Solid-state_relay

    A solid state relay (SSR) is an electronic switching device that switches on or off when an external voltage (AC or DC) is applied across its control terminals. They serve the same function as an electromechanical relay , but solid-state electronics contain no moving parts and have a longer operational lifetime.

  3. Bang–bang control - Wikipedia

    en.wikipedia.org/wiki/Bang–bang_control

    A water heater that maintains desired temperature by turning the applied power on and off (as opposed to continuously varying electrical voltage or current) based on temperature feedback is an example application of bang–bang control. Although the applied power switches from one discrete state to another, the water temperature will remain ...

  4. External Active Thermal Control System - Wikipedia

    en.wikipedia.org/wiki/External_Active_Thermal...

    The EATCS is capable of rejecting up to 70 kW, and provides a substantial upgrade in heat rejection capacity from the 14 kW capability of the Early External Active Thermal Control System (EEATCS) via the Early Ammonia Servicer (EAS), which was launched on STS-105 and installed onto the P6 Truss. [1]

  5. Silicon controlled rectifier - Wikipedia

    en.wikipedia.org/wiki/Silicon_controlled_rectifier

    Unlike an SCR, an SCS can be triggered into conduction when a negative voltage/output current is applied to that same lead. SCSs are useful in practically all circuits that need a switch that turns on/off through two distinct control pulses. This includes power-switching circuits, logic circuits, lamp drivers, and counters.

  6. Proportional–integral–derivative controller - Wikipedia

    en.wikipedia.org/wiki/Proportional–integral...

    When it is desired to lower the controlled temperature the heating output is off, but there is no active cooling due to control output. Any overshoot of rising temperature can therefore only be corrected slowly; it cannot be forced downward by the control output. In this case the PID controller could be tuned to be over-damped, to prevent or ...

  7. OpenTherm - Wikipedia

    en.wikipedia.org/wiki/OpenTherm

    The sequencer also needs a sensor to measure the temperature of the combined output from the boilers and usually would also control a main circulation pump. What happens after a fault occurs (resequencing remaining units, passing fault messages through for display on the room controller, etc.) is also part of the sequencer functionality.

  1. Ads

    related to: temperature controller with ssr output