enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g 3. slow rpm 33h 4. slow rpm 33L rotation left 30L 33R rotation right 30R Indicators 49 flasher unit in 15, 15+, 15/54, +, +15, X 49a flasher unit out, indicator switch in 54L, S, S4, L 49b out 2. flasher circuit 49c out 3. flasher circuit C

3. Yazaki - Wikipedia

   en.wikipedia.org/wiki/Yazaki

   Yazaki Corporation (矢崎総業株式会社, Yazaki Sōgyō Kabushiki Kaisha) is a global automotive parts supplier with a focus on wire harnesses, instruments and components such as connectors and terminals. The company's origin and headquarters are in Japan, but in 2011, roughly 90% of its employees were outside the home country.

4. ALDL - Wikipedia

   en.wikipedia.org/wiki/ALDL

   There were at least four different connectors used with ALDL. [4] General Motors implemented both a 5-pin connector and a 12-pin connector, with the 12 pin connector (Packard/Delco/Delphi part number 12020043) being used in the vast majority of GM cars. Lotus implemented a 10-pin connector.

5. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #

6. Data link connector - Wikipedia

   en.wikipedia.org/wiki/Data_link_connector

   The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.