Search results
Results from the WOW.Com Content Network
In situations where a downward slope out of a building en route to a treatment system cannot be created, a special collection sump pit and grinding lift "sewage ejector" pump are needed. By contrast, potable water supply systems are pressurized up to 50 pounds per square inch (340 kPa) or more and so do not require a continuous downward slope ...
The grinder pump “station” consists of the pump, a tank, and an alarm panel. A pump for household use is usually 1 hp , 1.5 hp or 2 hp . A cutting mechanism macerates waste and grinds items that are not normally found in sewage, but may get flushed down the toilet.
KOS+ M openwell submersible pump. Small-scale sewage pumping is normally done by a submersible pump. This became popular in the early 1960s, when a guide rail system was developed to lift the submersible pump out of the pump station for repair, and ended the dirty and sometimes dangerous task of sending people into the sewage or wet pit. [1]
The most common sewage system for mobile tiny homes is the RV low-flush toilet with a holding tank, which use minimal water, but generate blackwater which needs to be emptied.
Effluent sewer systems are a much less common sewage disposal method than gravity sewer systems that use gravity, as well as pumping where needed, to send raw sewage and other wastewater straight from consumers to a sewage treatment plant. There are two main types of gravity sewers, sanitary and combined. Sanitary sewers only treat the ...
A vacuum ejector, or simply ejector, or aspirator, is a type of vacuum pump, which produces vacuum by means of the Venturi effect.. In an ejector, a working fluid (liquid or gaseous) flows through a jet nozzle into a tube that first narrows and then expands in cross-sectional area.
Where it is impossible or impractical to discharge sewage from a property into a gravity sanitary sewer, a pressure sewer may provide an alternative means of connection. A macerator pump in a pumping well close to the property ejects sewage through a small diameter high pressure pipe into the nearest gravity sewer. [9]
Electronic components used to make a simple water detector: battery, resistor, transistor, water sensor and piezoelectric buzzer for audible alert A water detector is an electronic device that is designed to detect the presence of water for purposes such as to provide an alert in time to allow the prevention of water leakage.