enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Coil winding technology - Wikipedia

   en.wikipedia.org/wiki/Coil_winding_technology

   Wire-Ø Cu 0,3 mm → CU1L=0,334 mm (According to the table) Coil width: should be 9 mm // 150 turns, coil inner diameter 8mm. a) Calculation of the winding width In the first iteration step, a winding with the same number of windings per layer is assumed or taken as a basis. 9/0,334 → 26,9 turns/layer → chosen 26 turns per layer

3. Electrical wiring - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring

   Electrical wiring is an electrical installation of cabling and associated devices such as switches, distribution boards, sockets, and light fittings in a structure. Wiring is subject to safety standards for design and installation. Allowable wire and cable types and sizes are specified according to the circuit operating voltage and electric ...

4. Electrical resistivity and conductivity - Wikipedia

   en.wikipedia.org/wiki/Electrical_resistivity_and...

   The SI unit of electrical resistivity is the ohm - metre (Ω⋅m). [1][2][3] For example, if a 1 m3 solid cube of material has sheet contacts on two opposite faces, and the resistance between these contacts is 1 Ω, then the resistivity of the material is 1 Ω⋅m. Electrical conductivity (or specific conductance) is the reciprocal of ...

5. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...

6. IEC 60228 - Wikipedia

   en.wikipedia.org/wiki/IEC_60228

   Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...

7. Circular mil - Wikipedia

   en.wikipedia.org/wiki/Circular_mil

   FPS units. 7.853 982 × 10−7 in2. A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It is equal to π /4 square mils or approximately 5.067 × 10−4 mm2. It is a unit intended for referring to the area of a wire with a circular cross section.