Search results
Results from the WOW.Com Content Network
Direct-sequence spread-spectrum transmissions multiply the symbol sequence being transmitted with a spreading sequence that has a higher rate than the original message rate. Usually, sequences are chosen such that the resulting spectrum is spectrally white. Knowledge of the same sequence is used to reconstruct the original data at the receiving ...
In a direct-sequence spread spectrum system, each bit in the pseudorandom binary sequence is known as a chip and the inverse of its period as chip rate; compare bit rate and symbol rate. In a frequency-hopping spread spectrum sequence, each value in the pseudorandom sequence is known as a channel number and the inverse of its period as the hop ...
Hughes Software Systems, Multi Carrier Code Division Multiple Access, March 2002. German Aerospace Center, Institute of Communications and Navigation, History of Multi-Carrier Code Division Multiple Access (MC-CDMA) and Multi-Carrier Spread Spectrum Workshop, November 2006. Wireless Communication Reference Web Site, section about MC-CDMA, 2001.
Moreover, for a given noise power spectral density (PSD), spread-spectrum systems require the same amount of energy per bit before spreading as narrowband systems and therefore the same amount of power if the bitrate before spreading is the same, but since the signal power is spread over a large bandwidth, the signal PSD is much lower — often ...
CDMA is a spread-spectrum multiple-access technique. A spread-spectrum technique spreads the bandwidth of the data uniformly for the same transmitted power. A spreading code is a pseudo-random code in the time domain that has a narrow ambiguity function in the frequency domain, unlike other narrow pulse codes. In CDMA a locally generated code ...
Barker codes of length N equal to 11 and 13 are used in direct-sequence spread spectrum and pulse compression radar systems because of their low autocorrelation properties (the sidelobe level of amplitude of the Barker codes is 1/N that of the peak signal). [15]
BPSK (also sometimes called PRK, phase reversal keying, or 2PSK) is the simplest form of phase shift keying (PSK). It uses two phases which are separated by 180° and so can also be termed 2-PSK. It does not particularly matter exactly where the constellation points are positioned, and in this figure they are shown on the real axis, at 0° and ...
In a binary direct-sequence system, each chip is typically a rectangular pulse of +1 or −1 amplitude, which is multiplied by a data sequence (similarly +1 or −1 representing the message bits) and by a carrier waveform to make the transmitted signal. The chips are therefore just the bit sequence out of the code generator; they are called ...