Search results
Results from the WOW.Com Content Network
MAX232 chip in DIP-16 package The die of a MAX232 MAX232 pinout: Red: power, Yellow: charge pump capacitors, Blue: outputs, Green: inputs, Pins 9–12: TTL/CMOS I/O voltages. The MAX232 is an integrated circuit by Maxim Integrated Products, now a subsidiary of Analog Devices, that converts signals from a TIA-232 (RS-232) serial port to signals suitable for use in TTL-compatible digital logic ...
A standard-sized 8-pin dual in-line package (DIP) containing a 555 IC.. Integrated circuits and certain other electronic components are put into protective packages to allow easy handling and assembly onto printed circuit boards and to protect the devices from damage.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
The former Soviet Union and Eastern bloc countries used similar packages, but with a metric pin-to-pin spacing of 2.5 mm rather than 0.1 inches (2.54 mm). The number of leads is always even. For 0.3 inch spacing, typical lead counts are 8, 14, 16, and 20; less common are 4, 6, 18, 24, and 28 lead counts.
Conversely, the 4000-series has "borrowed" from the 7400 series – such as the CD40193 and CD40161 being pin-for-pin functional replacements for 74C193 and 74C161. Older TTL parts made by manufacturers such as Signetics , Motorola , Mullard and Siemens may have different numeric prefix and numbering series entirely, such as in the European FJ ...
HDBaseT connectors at a presentation and collaboration system from WolfVision. HDBaseT is a consumer electronic (CE) and commercial connectivity standard for transmission of uncompressed ultra-high-definition video, digital audio, DC power, Ethernet, USB 2.0, and other control communication (such as RS-232 and Consumer IR) over a single category cable (Cat 5e or better) up to 100 m (328 ft) in ...
DMX512-A uses a single pair of conductors, so can be connected using the cheaper 3-pin XLR connectors. Some manufacturers made units with three-pin XLR connectors, because of their lower cost. However, as 3-pin XLRs are commonly used for connecting microphones and sound mixing consoles , there is a risk of wrongly connecting DMX512 equipment to ...
The third pin connected to the case. The two pins of the TO-41 package end in soldering pads with holes in them to make it easier to solder wires to the pins for point-to-point construction (as opposed to soldering a TO-3 package on a printed circuit board). Otherwise the TO-41 package has the same dimensions as the TO-3 package. [6]