Ads
related to: difference between 2 and 4 ramebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
DDR4 RAM operates at a voltage of 1.2 V and supports frequencies between 800 and 1600 MHz (DDR4-1600 through DDR4-3200). Compared to DDR3, which operates at 1.5 V with frequencies from 400 to 1067 MHz (DDR3-800 through DDR3-2133), DDR4 offers better performance and energy efficiency .
The DDR4 SDRAM is a high-speed dynamic random-access memory internally configured as 16 banks, 4 bank groups with 4 banks for each bank group for ×4/×8 and 8 banks, 2 bank groups with 4 banks for each bank group for ×16 DRAM. The DDR4 SDRAM uses an 8n prefetch architecture to achieve high-speed operation.
Usually several memory cells share the same address. For example, a 4 bit "wide" RAM chip has four memory cells for each address. Often the width of the memory and that of the microprocessor are different, for a 32 bit microprocessor, eight 4 bit RAM chips would be needed. Often more addresses are needed than can be provided by a device.
Each bit in the cell is stored on four transistors (M1, M2, M3, M4) that form two cross-coupled inverters. This storage cell has two stable states which are used to denote 0 and 1. Two additional access transistors serve to control the access to a storage cell during read and write operations. 6T SRAM is the most common kind of SRAM. [20]
There is only a little difference between a dual rank UDIMM and two single-rank UDIMMs in the same memory channel, other than that the DRAMs reside on different PCBs. The electrical connections between the memory controller and the DRAMs are almost identical (with the possible exception of which chip selects go to which ranks).
A typical computer has only a single memory controller with only one or two channels. The logical features section described NUMA configurations, which can take the form of a network of memory controllers. For example, each socket of a two-socket AMD K8 can have a two-channel memory controller, giving the system a total of four memory channels.
DDR2 and DDR3 increased this factor to 4× and 8×, respectively, delivering 4-word and 8-word bursts over 2 and 4 clock cycles, respectively. The internal access rate is mostly unchanged (200 million per second for DDR-400, DDR2-800 and DDR3-1600 memory), but each access transfers more data.
The operating system will place actively used data in RAM, which is much faster than hard disks. When the amount of RAM is not sufficient to run all the current programs, it can result in a situation where the computer spends more time moving data from RAM to disk and back than it does accomplishing tasks; this is known as thrashing.
Ads
related to: difference between 2 and 4 ramebay.com has been visited by 1M+ users in the past month