Search results
Results from the WOW.Com Content Network
A wildcard mask is a mask of bits that indicates which parts of an IP address are available for examination. In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists ...
Since the introduction of CIDR, however, the assignment of an IP address to a network interface requires two parameters, the address and a subnet mask. Given an IPv4 source address, its associated subnet mask, and the destination address, a router can determine whether the destination is on a locally connected network or a remote network. The ...
Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private ...
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
IP addresses in dot-decimal notation are also presented in CIDR notation, in which the IP address is suffixed with a slash and a number, used to specify the length of the associated routing prefix. For example, 127.0.0.1/8 specifies that the IP address has an eight-bit routing prefix, and therefore the subnet mask 255.0.0.0 .
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
A multicast address is a logical identifier for a group of hosts in ... IP multicast address range ... Routers must not forward these messages outside the subnet from ...
2. Subnet mask (The /12 in the IP address in this case means only the left-most 12 bits are 1s, as shown here. This reserves the left 12 bits for the network address (prefix) and the right 32 - 12 = 20 bits for the host address (suffix).) 11111111.11110000.00000000.00000000: 255.240.0.0 3. Bit complement (bitwise NOT) of the subnet mask