enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. French catheter scale - Wikipedia

   en.wikipedia.org/wiki/French_catheter_scale

   The French scale measures the outer diameter of the catheter, not the size of the internal drainage channel (inner diameter). For instance, a two-way catheter of 20 Fr and a three-way catheter of 20 Fr have the same outer diameter, but the three-way catheter has an additional channel for irrigation, reducing the size of its drainage channel.

3. Iron pipe size - Wikipedia

   en.wikipedia.org/wiki/Iron_pipe_size

   The iron pipe size standard came into being early in the 19th century and remained in effect until after World War II. The IPS system was primarily used in the United States and the United Kingdom. In the 1920s, the Copper Tube Size (CTS) standard was combined with the IPS standard.

4. Tube (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Tube_(fluid_conveyance)

   A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch pipe will not actually measure 1 inch in either outside or inside diameter, whereas many types of tubing are ...

5. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.

6. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness. Each AN size also uses its own standard thread size. AN fittings are a flare fitting, using 37° flared tubing to form a metal-to-metal seal.

8. Tube socket - Wikipedia

   en.wikipedia.org/wiki/Tube_socket

   The octal base provided one more conductor with a smaller overall size of the base than the previous line of U. S. tube bases which had provided a maximum of seven conductors. Octal bases, as defined in IEC 60067, [ 10 ] diagram IEC 67-I-5a, have a 45-degree angle between pins, which form a 17.45 mm ( 11 ⁄ 16 in) diameter circle around a 7.82 ...

9. List of vacuum tubes - Wikipedia

   en.wikipedia.org/wiki/List_of_vacuum_tubes

   110–119 – Y8A 8-pin steel tube base; Rimlock B8A; 130–139 – Octal; 150–159 – German 10-pin with spigot; 10-pin glass with one big pin; Octal; 160–169 – Inline wire-ended Pencil tubes; Y8A 8-pin steel tube base; 170–179 – RFT 8-pin; RFT 11-pin all-glass gnome tube with one offset pin; 180–189 – Noval B9A; 190–199 ...