Search results
Results from the WOW.Com Content Network
A Queued Serial Peripheral Interface (QSPI; different to but has same abbreviation as Quad SPI described in § Quad SPI) is a type of SPI controller that uses a data queue to transfer data across an SPI bus. [19] It has a wrap-around mode allowing continuous transfers to and from the queue with only intermittent attention from the CPU.
Thus, Intel describes a 20-lane QPI link pair (send and receive) with a 3.2 GHz clock as having a data rate of 25.6 GB/s. A clock rate of 2.4 GHz yields a data rate of 19.2 GB/s. More generally, by this definition a two-link 20-lane QPI transfers eight bytes per clock cycle, four in each direction. The rate is computed as follows: 3.2 GHz
Devices implementing SPI are typically specified with line rates of 700~800 Mbit/s and in some cases up to 1 Gbit/s. The latest version is SPI 4 Phase 2 also known as SPI 4.2 delivers bandwidth of up to 16 Gbit/s for a 16 bit interface. The Interlaken protocol, a close variant of SPI-5 replaced the System Packet Interface in the marketplace.
QuickPath Interconnect (QPI) by Intel (though this is an off-chip interface, not on-chip bus) virtual share from PICC - free and open source; TileLink - Free and open bus architecture from CHIPS Alliance [6]
UPI only supports directory-based coherency, unlike previous QPI processors which supported multiple snoop modes (no snoop, early snoop, home snoop, and directory). A combined caching and home agent (CHA) handles resolution of coherency across multiple processors, as well as snoop requests from processor cores and local and remote agents.
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.
In contrast, Uncore functions include QPI controllers, L3 cache, snoop agent pipeline, on-die memory controller, on-die PCI Express Root Complex, and Thunderbolt controller. [3] Other bus controllers such as SPI and LPC are part of the chipset. [4] The Intel uncore design stems from its origin as the northbridge. The design of the Intel uncore ...
SCPI was defined as an additional layer on top of the IEEE 488.2-1987 specification "Standard Codes, Formats, Protocols, and Common Commands". [4] The standard specifies a common syntax, command structure, and data formats, to be used with all instruments.