Search results
Results from the WOW.Com Content Network
Some devices with dual-band wireless network connectivity do not allow the user to select the 2.4 GHz or 5 GHz band (or even a particular radio or SSID) when using Wi-Fi Protected Setup, unless the wireless access point has separate WPS button for each band or radio; however, a number of later wireless routers with multiple frequency bands and ...
In computer networking, a wireless access point (WAP) (also just access point (AP)) is a networking hardware device that allows other Wi-Fi devices to connect to a wired network or wireless network. As a standalone device, the AP may have a wired or wireless connection to a switch or router , but in a wireless router it can also be an integral ...
A wireless configuration utility, [1] wireless configuration tool, [1] wireless LAN client, [citation needed] or wireless connection management utility [citation needed] is a class of network management software that manages the activities and features of a wireless network connection.
Wi-Fi positioning system (WPS, WiPS or WFPS) is a geolocation system that uses the characteristics of nearby Wi‑Fi access points to discover where a device is located. [1]It is used where satellite navigation such as GPS is inadequate due to various causes including multipath and signal blockage indoors, or where acquiring a satellite fix would take too long. [2]
All wireless nodes in an infrastructure mode network connect to an access point. All nodes connecting to the access point must have the same service set identifier (SSID) as the access point. If wireless security is enabled on the access point (such as WEP or WPA), the NIC must have valid authentication parameters in order to connect to the ...
A wireless access point (WAP) connects a group of wireless devices to an adjacent wired LAN. An access point resembles a network hub, relaying data between connected wireless devices in addition to a (usually) single connected wired device, most often an Ethernet hub or switch, allowing wireless devices to communicate with other wired devices.
WEP used a 64-bit or 128-bit encryption key that must be manually entered on wireless access points and devices and does not change. TKIP employs a per-packet key, meaning that it dynamically generates a new 128-bit key for each packet and thus prevents the types of attacks that compromised WEP. [4]
Key Transfer Phase: All four encryption keys are transmitted to the client regardless of encryption support, allowing the client to change the SSID if needed. The user does not have access to the keys through the client device. Reboot Stack: The AP applies the SSID and key for the highest level of encryption supported by the client and reboots ...