Search results
Results from the WOW.Com Content Network
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
Sharp NEC Display Solutions (Sharp/NEC; formerly NEC Display Solutions or NDS and NEC-Mitsubishi Electric Visual Systems or NEC-Mitsubishi or NM Visual) is a manufacturer of computer monitors and large-screen public-information displays, and has sold and marketed products under the NEC brand globally for more than twenty years.
In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...
All miniature bulbs, including some LED sets, have a wedge base, though their designs are inconsistent with one another, making it somewhat difficult for the average consumer to change bulbs. To replace a bulb, the plastic base of the bulb must usually be changed by straightening the two wires and pulling the glass part out. Most replacement ...
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
Ultra-high-performance lamp. An ultra-high-performance lamp, often known by the Philips trademark UHP, is a high-pressure mercury arc lamp. [1] These were originally known as ultra-high-pressure lamps, [2] [3] because the internal pressure can rise to as much as 200 atmospheres when the lamp reaches its operating temperature.
A projector that is set to a lower maximum brightness will generally last longer. [5] No bulbs to replace after only a couple thousand hours (as with xenon-backlit DLP and LCD); however, CRT projectors can accumulate burn-in if set to a high contrast value and/or displaying static content over time
In contrast, a modern LCD or DLP projector often uses an Ultra-high-performance lamp which has a higher luminous efficacy and lasts for thousands of hours. [5] A drawback of that technology is the warm up time required for such lamps. Older overhead projectors used a tubular quartz bulb which was mounted above a bowl-shaped polished reflector.