Search results
Results from the WOW.Com Content Network
ftin (feet and inches) ft m (foot m) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Other: nautical mile: nmi nmi the international standard nautical mile For other nautical miles see the full list. 1.0 nmi (1.9 km; 1.2 mi) parsec: pc pc 1.0 pc (3.3 ly) light-year: ly ly 1.0 ly (63,000 AU ...
The important socket dimensions which the standard does specify are: A minimum insertion of 9.6 mm from the face of the socket-outlet to the first point of contact with a live part, [67] a minimum distance of 9.5 mm from the line and neutral apertures to the periphery of the socket face, [68] and not to exceed dimensions for the apertures of 7. ...
The flat pins for the 10 A version measure 6.25 by 1.55 mm (0.246 by 0.061 in) and 8.0 by 1.9 mm (0.315 by 0.075 in) for the 20 A version, and are set at 30° to the vertical at a nominal pitch of 7.92 mm (0.312 in). The pin length is the same as in the Chinese version. The earthing pin length is 21.4 mm (0.843 in) for the 10 A version and 21.8 ...
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
Many non-proprietary co-axial power plugs are 5.5 mm (0.22 in) in outside diameter (OD) and 9.5 mm (0.37 in) in length. Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
OD (mm) ID (mm) CPD (mm) Barrel length (mm) Adaptaplug Standard Volts Plug part numbers Jack part numbers Notes 2.00 0.60 6.3 Nokia 2-mm DC Charging Interface Specification [3] 4.65–9.3 V Nokia DC-096 (0.48×2.1 mm on socket side) Nokia AC-3 charger Nokia 2-mm DC Charging Interface, used in Nokia phones and Bluetooth headphones 2.35 0.70 9.5 A
The telephone jack of manual telephone switchboards, which is the socket fitting the original 1 ⁄ 4 inch (6.35 mm) telephone plug; The 1 ⁄ 4 inch (6.35 mm) phone jack common to many electronic applications in various configurations, sometimes referred to as a headphone jack