Search results
Results from the WOW.Com Content Network
At 20 °C and 101.325 kPa, dry air has a density of 1.2041 kg/m 3. At 70 °F and 14.696 psi, dry air has a density of 0.074887 lb/ft 3. The following table illustrates the air density–temperature relationship at 1 atm or 101.325 kPa: [citation needed]
Standard sea-level conditions (SSL), [1] also known as sea-level standard (SLS), defines a set of atmospheric conditions for physical calculations.The term "standard sea level" is used to indicate that values of properties are to be taken to be the same as those standard at sea level, and is done to define values for use in general calculations.
The relative density of gases is often measured with respect to dry air at a temperature of 20 °C and a pressure of 101.325 kPa absolute, which has a density of 1.205 kg/m 3. Relative density with respect to air can be obtained by =, where is the molar mass and the approximately equal sign is used because equality pertains only if 1 mol of the ...
The density of air at sea level is about 1.2 kg/m 3 (1.2 g/L, 0.0012 g/cm 3). Density is not measured directly but is calculated from measurements of temperature, pressure and humidity using the equation of state for air (a form of the ideal gas law). Atmospheric density decreases as the altitude increases.
In case of air, using the perfect gas law and the standard sea-level conditions (SSL) (air density ρ 0 = 1.225 kg/m 3, temperature T 0 = 288.15 K and pressure p 0 = 101 325 Pa), we have that R air = P 0 /(ρ 0 T 0) = 287.052 874 247 J·kg −1 ·K −1. Then the molar mass of air is computed by M 0 = R/R air = 28.964 917 g/mol. [11]
Ratings found in centrifugal fan performance tables and curves are based on standard cubic feet per minute (SCFM). Fan manufacturers define standard air as clean, dry air with a density of 0.075 pounds mass per cubic foot, with the atmospheric pressure at sea level of 29.92 inches of mercury and a temperature of 70°F.
K) specific gas constant for dry air ρa = P_a / (Rs_a * Tair) return ρa end # Wet air density ρ [kg/m3] # Tair air temperature in [Kelvin] # P absolute atmospheric pressure [Pa] function wet_air_density (RH, Tair, P) es = water_vapor_saturated_pressure (Tair, P) e = es * RH / 100 ρv = water_vapor_density (e, Tair) ρa = dry_air_density (P-e ...
at each geopotential altitude, where g is the standard acceleration of gravity, and R specific is the specific gas constant for dry air (287.0528J⋅kg −1 ⋅K −1). The solution is given by the barometric formula. Air density must be calculated in order to solve for the pressure, and is used in calculating dynamic pressure for moving vehicles.