Search results
Results from the WOW.Com Content Network
A team of riggers design and install the lifting or rolling equipment needed to raise, roll, slide or lift objects such as heavy machinery, structural components, building materials, or large-scale fixtures with a crane, hoist or block and tackle. Rigging comes from rig, to set up or prepare.
Sailors could put their rope skills to work in lifting and hauling. In an era before mechanical haulage and cranes, ropes, pulleys and muscle power were all that was available to move heavy objects. A specialized subset are telecommunication riggers, entertainment industry riggers.
Lifting equipment, also known as lifting gear, is a general term for any equipment that can be used to lift and lower loads. [1] Types of lifting equipment include heavy machinery such as the patient lift , overhead cranes , forklifts , jacks , building cradles, and passenger lifts, and can also include smaller accessories such as chains ...
In practice, sets of elevators and a spare duplicate are required on-site for general operations. Their failure almost always stops operations. To latch around a piece of pipework a set of elevators need a precise internal diameter, with an appropriately profiled shoulder to accommodate the lower profile of a tool joint.
Rigging of an asymmetrical scaffolding piece: the lifting beam is blue, the load is attached to the beam using grey slings. The lifting beam (also known as traverse, spreader beam) is a steel beam that is attached to the hook of the crane in order to spread the slings from one end of an elongated load (like a wall panel) to another. The bottom ...
Pipe ramming (sometimes also called pipe jacking) is a trenchless method for installation of steel pipes and casings. Distances of 30 m (150 feet) or more and over 500 mm (20 inches) in diameter are common, although the method can be used for much longer and larger installations.
Drill pipe makes up the majority of the drill string back up to the surface. Each drill pipe comprises a long tubular section with a specified outside diameter (e.g. 3 1/2 inch, 4 inch, 5 inch, 5 1/2 inch, 5 7/8 inch, 6 5/8 inch). At each end of the drill pipe, tubular larger-diameter portions called the tool joints are located.
It is made from three pieces of rectangular-section 13 mm (0.51 in)-thick steel legs held together with a shackle, allowing connection to a lifting hook. The middle leg is square throughout its length, while the outer legs are thinner at the top, flaring towards the bottom. Held together, the three legs thus form a dovetail shape.