Search results
Results from the WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available for virtually all operating systems that have networking capability, including most embedded network administration software. Ping measures the round-trip time for messages sent from the ...
PathPing. The PathPing command is a command-line network utility included in Windows NT operating systems since Windows 2000 that combines the functionality of ping with that of tracert. [ 1] It is used to locate spots that have network latency and network loss. [ 2][ 3]
The ipconfig command supports the command-line switch /all. This results in more detailed information than ipconfig alone. An important additional feature of ipconfig is to force refreshing of the DHCP IP address of the host computer to request a different IP address. This is done using two commands in sequence.
traceroute. In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
netstat. In computing, netstat ( network statistics) is a command-line network utility that displays network connections for Transmission Control Protocol (both incoming and outgoing), routing tables, and a number of network interface ( network interface controller or software-defined network interface) and network protocol statistics.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for duplex , bidirectional traffic.
Requests the direct IP address of the user with the specified nickname. This command is often used to obtain the IP of an abusive user to more effectively perform a ban. It is unclear what, if any, privileges are required to execute this command on a server. This command is not formally defined by an RFC, but is in use by some IRC daemons.
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256