Ads
related to: manual crimper for hydraulic hose connectors locked video on facebook site
Search results
Results from the WOW.Com Content Network
A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).
An electrical crimp is a type of solderless electrical connection which uses physical pressure to join the contacts. Crimp connectors are typically used to terminate stranded wire. [4] Stripped wire is inserted through the correctly sized opening of the connector, and a crimper is used to tightly squeeze the opening against the wire.
For these high pressure applications, compression fittings, thick crimp fittings, or other designs are normally used. Hose clamps are frequently used for things other than their intended use, and are often used as a more permanent version of duct tape wherever a tightening band around something would be useful. The screw band type in particular ...
Two banjo fittings (upper center of photo) atop automotive brake calipers. The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids ...
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A split beam nut; A castellated nut and a split pin; A hex nut or cap screw and a tab washer
A selection of Storz hose couplings. A hose coupling is a connector on the end of a hose to connect (or couple) it with another hose or with a tap or a hose appliance, such as an irrigation sprinkler. It is usually made of steel, brass, stainless steel, aluminium or plastic.
Another type of manual wire stripper is very similar to the simple design previously mentioned, except this type has several notches of varying size. This allows the user to match the notch size to the wire size, thereby eliminating the need for twisting, but can only be used on wire sizes that approximately match one of the notches.
Ads
related to: manual crimper for hydraulic hose connectors locked video on facebook site