Search results
Results from the WOW.Com Content Network
Here is a similar formula from the 67th edition of the CRC handbook. Note that the form of this formula as given is a fit to the Clausius–Clapeyron equation, which is a good theoretical starting point for calculating saturation vapor pressures: log 10 (P) = −(0.05223)a/T + b, where P is in mmHg, T is in kelvins, a = 38324, and b = 8.8017.
Methanol is a promising energy carrier because, as a liquid, it is easier to store than hydrogen and natural gas. Its energy density is, however, lower than methane, per kg. Its combustion energy density is 15.6 MJ/L , whereas that of ethanol is 24 and gasoline is 33 MJ/L.
Methanol fuel is an alternative biofuel for internal combustion and other engines, either in combination with gasoline or independently. Methanol (CH 3 OH) is less expensive to sustainably produce than ethanol fuel, although it is more toxic than ethanol and has a lower energy density than gasoline.
Density: kg/L: kg/L: 1000: kilogram per litre: kilograms per litre: kilogram per liter: kilograms per liter: lb/USgal: Density: kg/l: kg/l: 1000: kilogram per litre: kilograms per litre: kilogram per liter: kilograms per liter: lb/USgal: Density: kg/m3: kg/m 3: 1: kilogram per cubic metre: kilograms per cubic metre: kilogram per cubic meter ...
The Wobbe index is expressed in MJ/Nm³ (where 'Nm³' indicates'm³ in Normal conditions), or sometimes in BTU/scf.In the case of natural gas (molar mass 17 g/mol), the typical heating value is around 39 MJ/Nm³ (1,050 BTU/scf) and the specific gravity is approximately 0.59, giving a typical Wobbe index of 51 MJ/Nm³ (1,367 BTU/scf).
The density of thermal energy contained in the core of a light-water reactor (pressurized water reactor (PWR) or boiling water reactor (BWR)) of typically 1 GW (1000 MW electrical corresponding to ≈ 3000 MW thermal) is in the range of 10 to 100 MW of thermal energy per cubic meter of cooling water depending on the location considered in the ...
Syngas has less than half the energy density of natural gas. [11] The first reaction, between incandescent coke and steam, is strongly endothermic, producing carbon monoxide (CO) and hydrogen H 2 (water gas in older terminology). When the coke bed has cooled to a temperature at which the endothermic reaction can no longer proceed, the steam is ...
Specific energy is energy per unit mass, which is used to describe the chemical energy content of a fuel, expressed in SI units as joule per kilogram (J/kg) or equivalent units. [1] Energy density is the amount of chemical energy per unit volume of the fuel, expressed in SI units as joule per litre (J/L) or equivalent units. [2]