Search results
Results from the WOW.Com Content Network
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.
In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc.
Example of true position geometric control defined by basic dimensions and datum features. Geometric dimensioning and tolerancing (GD&T) is a system for defining and communicating engineering tolerances via a symbolic language on engineering drawings and computer-generated 3D models that describes a physical object's nominal geometry and the permissible variation thereof.
ASME Y14.5 is a complete definition of Geometric Dimensioning and Tolerancing. It contains 15 sections which cover symbols and datums as well as tolerances of form, orientation, position, profile and runout. [3] It is complemented by ASME Y14.5.1 - Mathematical Definition of Dimensioning and Tolerancing Principles.
The standard (size) tolerances are divided into two categories: hole and shaft. They are labelled with a letter (capitals for holes and lowercase for shafts) and a number. For example: H7 (hole, tapped hole, or nut) and h7 (shaft or bolt). H7/h6 is a very common standard tolerance which gives a tight fit.
The gap between the flange faces has been exaggerated by a factor of four to make it clearly visible. The choke flange can also be mated with a plain cover flange and still form a pressure seal. A choke connection is formed by mating one choke flange and one cover (or gasket/cover) flange. The central region of the choke flange face is very ...
The lower image is a plain plug gauge used to check the size of a hole; the green end is the go, and the red end is the no-go. The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance. This may be initially ...