Search results
Results from the WOW.Com Content Network
Power amplifier circuits (output stages) are classified as A, B, AB and C for linear designs—and class D and E for switching designs. The classes are generally based on the proportion of each input cycle (conduction angle) during which an amplifying device passes current. [2]
A practical amplifier circuit. The practical amplifier circuit shown above could be the basis for a moderate-power audio amplifier. It features a typical (though substantially simplified) design as found in modern amplifiers, with a class-AB push–pull output stage, and uses some overall negative feedback. Bipolar transistors are shown, but ...
A conventional amplifier stage which is not push–pull is sometimes called single-ended to distinguish it from a push–pull circuit. In analog push–pull power amplifiers the two output devices operate in antiphase (i.e. 180° apart). The two antiphase outputs are connected to the load in a way that causes the signal outputs to be added, but ...
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
MOSFET-input operational amplifiers often have protection circuits that effectively short circuit any input differences greater than a small threshold, so the input impedance can appear to be very low in some tests. However, as long as these operational amplifiers are used in a typical high-gain negative feedback application, these protection ...
A differential amplifier is a type of electronic amplifier that amplifies the difference between two input voltages but suppresses any voltage common to the two inputs. [1] It is an analog circuit with two inputs and + and one output , in which the output is ideally proportional to the difference between the two voltages:
A paralleled configuration of two amplifier channels delivers the same power and halves dissipation. So when both configurations are combined on a set of four single-ended amplifiers, the power output is increased four-fold but the power dissipation of each constituent amplifier is not increased, and thermal issues are easier to handle.
Power electronics is the application of electronics to the control and conversion of electric power. The first high-power electronic devices were made using mercury-arc valves . In modern systems, the conversion is performed with semiconductor switching devices such as diodes , thyristors , and power transistors such as the power MOSFET and IGBT .