Search results
Results from the WOW.Com Content Network
Screw foundations first appeared in the 1800s as pile foundations for lighthouses, [3] and were extensively used for piers in harbours. Between the 1850s through 1890s, more than 100 screw-pile lighthouses were erected on the east coast of the United States using screw piles. Made originally from cast or wrought iron, they had limited bearing ...
The ground tab is designed to be attached to the outlet faceplate screw, which is supposed to be connected to the building electrical ground. A cheater plug, AC ground lifter or three-prong/two-prong adapter is an adapter that allows a NEMA 5-15P grounding-type plug (three prongs) to connect to a NEMA 1-15R non-grounding receptacle (two slots).
A newer stage pin connector. Note the GR denoting the longer ground pin, which is slightly off-center to prevent the plug being inserted upside down.. A stage pin connector, also known as a grounded stage pin (GSP), grounded pin connector (GPC) or theater paddle (TP), is a standard cable type for theatrical lighting in North America and in many countries in the theatre world.
The term fine adjustment screw typically refers to screws with threads from 40–100 TPI (Threads Per Inch) (0.5 mm to 0.2 mm pitch) and ultra fine adjustment screw has been used to refer to 100–254 TPI (0.2 mm to 0.1 mm pitch). These screws are most frequently used in applications where the screw is used to control fine motion of an object.
Isometric projection of a grub screw with a hex socket head. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts. The detent, however ...
Screw terminals, as individual connectors to a board at left, as a barrier strip with setscrews at top, and as a barrier strip with attached spade and loop lugs at bottom. A screw terminal is a type of electrical connection where a wire is held by the tightening of a screw.
Robertson screwdrivers are easy to use one-handed, because the tapered socket tends to retain the screw, even if it is shaken. [3]: 85–86 They also allow the use of angled screwdrivers and trim-head screws. The socket-headed Robertson screws are self-centering and reduce cam out. They also stop a power tool when set, and can be more easily ...
Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...