Search results
Results from the WOW.Com Content Network
The first sectional chart was published in 1930; in 1937 the full series of the lower 48 states was completed. These early sectional charts were smaller (most covered two degrees of latitude and six of longitude) with the map on one side; after 1950 the legend and index to adjoining charts was on the reverse.
The charts are published "in accordance with Interagency Air Cartographic Committee specifications and agreements, approved by the Department of Defense and the Federal Aviation Administration". The legend of an aeronautical chart lists many of the symbols, colors and codes used to convey information to the map reader.
FAA-Terminal Area Chart Baltimore-Washington from 2011. Like the VFR sectional charts that they complement, terminal area charts depict topographic features and other information of interest to aviators flying visually, including major landmarks, terrain elevations, visual navigation routes, ground-based navigation aids, airports, rivers, cities, and airspace boundaries.
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
A World Aeronautical Chart (WAC) was a type of aeronautical chart used for navigation by pilots of moderate speed aircraft and aircraft at high altitudes in the United States. They are at a scale of 1:1,000,000 (about 1 inch = 13.7 nautical miles or 16 statute miles).
En-route charts are divided into high and low versions, with information on airways and navaids for high- and low-altitude flight, respectively. The division between low altitude and high altitude is usually defined as the altitude that marks transition to flight levels (in the United States, this is taken to be 18,000 feet MSL by convention).
The airspace is charted on a VFR sectional chart with a series of blue lines. Within these blue lines, the floor and the ceiling of the Class B airspace is defined. The lateral boundaries of Class B airspace are individually tailored to facilitate arriving and departing traffic operating under IFR.
2006 USGS photo. Willow Run Airport covers 2,392 acres (968 ha) and has two runways, a continuously staffed FAA control tower, and US Customs operations. [1] It is one of two facilities operated by the Wayne County Airport Authority, the other being Detroit Metropolitan Airport, which replaced Willow Run as the major commercial airport for the region starting in 1958.