Search results
Results from the WOW.Com Content Network
Shallow pipes, which are buried in the zone of seasonal moisture fluctuation, are put under stress by shrinking soils, [3] which can cause breakage of water or sewage pipes. Swimming pool shells can crack due to this pressure as well, and leaky pools can also introduce a lot of water into the surrounding soils over time, which could end up ...
Vitrified clay pipe (VCP) is pipe made from a blend of clay and shale that has been subjected to high temperature to achieve vitrification, which results in a hard, inert ceramic. VCP is commonly used in gravity sewer collection mains because of its long life and resistance to almost all domestic and industrial sewage , particularly the ...
Subaqueous shrinkage cracks can develop on and through a surface that has been continuously covered in water. Syneresis cracks in some shales and lime mudstones may initially be preserved as small cavities, which then usually fill with silt and sand from either the overlying or underlying beds and laminae . [ 6 ]
When stress is applied that causes densification due to water (or other liquid) being displaced from between the soil grains, then consolidation, not compaction, has occurred. Normally, compaction is the result of heavy machinery compressing the soil , but it can also occur due to the passage of, for example, animal feet.
The plasticity index is the size of the range of water contents where the soil exhibits plastic properties. The PI is the difference between the liquid and plastic limits (PI = LL-PL). Soils with a high PI tend to be clay, those with a lower PI tend to be silt, and those with a PI of 0 (non-plastic) tend to have little or no silt or clay.
To make puddle, clay or heavy loam is chopped with a spade and mixed into a plastic state with water and sometimes coarse sand or grit to discourage excavation by moles or water voles. The puddle is laid about 10 inches (25 cm) thick at the sides and nearly 3 ft (0.91 m) thick at the bottom of a canal, built up in layers.
In the dry season, evaporation moves water from the deep horizon toward the soil surface through capillary action. The water removal results in shrinkage of clay, and the soil becomes dry and hard. In the wet season, high precipitation leads to a swell of clay to absorb water. The high moisture content results in wet and sticky clay texture.
Grog, temper for clay. Grog, also known as firesand and chamotte, is a raw material usually made from crushed and ground potsherds, reintroduced into crude clay to temper it before making ceramic ware. It has a high percentage of silica and alumina. It is normally available as a powder or chippings, and is an important ingredient in Coade stone.