Search results
Results from the WOW.Com Content Network
Ethernet Configuration Testing Protocol is a diagnostic protocol included in the Xerox Ethernet II specification. [1] Functionality of the protocol is similar to that offered by ping but it operates at the data link layer as opposed to the network layer.
Loop around is a method of testing between stations that are not necessarily adjacent, wherein two lines are used, with the test being done at one station and the two lines are interconnected at the distant station. A patch cable may also function as loopback, when applied manually or automatically, remotely or locally, facilitating a loop-back ...
While any free port can be configured as a mirror port, software taps require configuration and place load on the network devices. Even fully passive network taps introduce new points of failure into the network. There are several ways that taps can cause problems, and this should be considered when creating a tap architecture.
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
Most of the interchange circuits are Category I, with the exception of Local Loopback (pin 18), Remote Loopback (pin 21), and Test Mode (pin 25) being Category II. TIA-530 originally used Category I circuits for what is commonly called "Data Set Ready" (DCE Ready, pins 6 and 22) and "Data Terminal Ready" (DTE Ready, pins 20 and 23).
An Ethernet port on a laptop computer connected to a twisted pair cable with an 8P8C modular connector Symbol used by Apple and Google on some devices to denote an Ethernet connection Ethernet ( / ˈ iː θ ər n ɛ t / EE -thər-net ) is a family of wired computer networking technologies commonly used in local area networks (LAN), metropolitan ...
The connector commonly used for twisted-pair Ethernet is a non-keyed 8P8C connector, quite distinct from that used for RJ45S. The new ARJ45 interface, however, is a plug and jack allowing higher transmission rates, and the jack can, optionally, be backward-compatible with the common 8P8C plugs of Gigabit Ethernet and earlier standards.
Bandwidth test software is used to determine the maximum bandwidth of a network or internet connection. It is typically undertaken by attempting to download or upload the maximum amount of data in a certain period of time, or a certain amount of data in the minimum amount of time.