enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Knot density - Wikipedia

   en.wikipedia.org/wiki/Knot_density

   The inverse, knot ratio, is also used to compare characteristics. [5] [6] Knot density = warp×weft while knot ratio = warp/weft. For comparison: 100,000/square meter = 1,000/square decimeter = 65/square inch = 179/gereh. For two carpets of the same age, origin, condition and design, the one with the higher number of knots will be the more ...

3. List of conversion factors - Wikipedia

   en.wikipedia.org/wiki/List_of_conversion_factors

   See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, while Troy weight is the system of mass where 12 troy ounces equals one troy pound. The symbol g 0 is used to denote standard gravity in order to avoid confusion with the (upright) g symbol for gram.

4. Floor area ratio - Wikipedia

   en.wikipedia.org/wiki/Floor_area_ratio

   Floor Area ratio is sometimes called floor space ratio (FSR), floor space index (FSI), site ratio or plot ratio. The difference between FAR and FSI is that the first is a ratio, while the latter is an index. Index numbers are values expressed as a percentage of a single base figure. Thus an FAR of 1.5 is translated as an FSI of 150%.

5. Floor area - Wikipedia

   en.wikipedia.org/wiki/Floor_area

   Hong Kong law Chapter 123F, Building (Planning) Regulations, Regulation 23 sect 3 sub-paragraph (a) defined that: Subject to sub-paragraph (b), for the purposes of regulations 19, 20, 21 and 22, the gross floor area of a building shall be the area contained within the external walls of the building measured at each floor level (including any floor below the level of the ground), together with ...

6. Builder's Old Measurement - Wikipedia

   en.wikipedia.org/wiki/Builder's_Old_Measurement

   Length is the length (undefined), in feet; Beam is the beam, in feet. Depth is the depth of the hold, in feet below the main deck. The numerator yields the ship's volume expressed in cubic feet. If a "tun" is deemed to be equivalent to 100 cubic feet, then the tonnage is simply the number of such 100 cubic feet 'tun' units of volume.

7. List of unusual units of measurement - Wikipedia

   en.wikipedia.org/wiki/List_of_unusual_units_of...

   One brass is exactly 100 square feet (9.29 m 2) area (used in measurement of work done or to be done, such as plastering, painting, etc.). The same word is used, however, for 100 cubic feet (2.83 m 3 ) of estimated or supplied loose material, such as sand, gravel, rubble, etc.