Search results
Results from the WOW.Com Content Network
The AV-sync delay is normally fixed. External AV-sync errors can occur if a microphone is placed far away from the sound source, the audio will be out of sync because the speed of sound is much lower than the speed of light. If the sound source is 340 meters from the microphone, then the sound arrives approximately 1 second later than the light.
The audio of a TS is captured with a direct connection to the sound source (often an FM microbroadcast provided for the hearing-impaired, or from a drive-in theater). If a direct connection from the sound source is not possible, sometimes the bootlegger will tape or conceal wireless microphones close to the speakers, as it is better than a mic ...
The audio synchronizer receives the DDO signal and in response delays the audio by an equivalent amount, thereby maintaining proper audio-video sync. Modern audio synchronizers operate by digitizing and writing the audio signal into a ring memory, which is most commonly a RAM -based memory having independent read and write ability.
A cable conducts the sync pulse from camera to sound recorder. The sync pulse is typically a sine wave of 50 or 60 Hz with an RMS amplitude of approximately 1 volt. [4] This double-system audio recording could then be transferred or "resolved" to sprocketed magnetic film, with sprocket holes that match one to one with the original camera film.
Audio signal flow is the path an audio signal takes from source to output. [1] The concept of audio signal flow is closely related to the concept of audio gain staging; each component in the signal flow can be thought of as a gain stage. In typical home stereo systems, the signal flow is usually short and simple, with only a few components.
Situational circumstances: Sometimes a microphone should not be visible, or having a microphone nearby is not appropriate. In scenes for a movie the microphone may be held above, out of the picture frame. Processing: If the signal is destined to be heavily processed, or mixed down, a different type of input may be required.
Often designated by the CVBS acronym, meaning "Color, Video, Blank and Sync". RCA jack, normally yellow (often accompanied with red and white for right and left audio channels respectively) S-Video (Separate Video). Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers ...
Audio engineers experienced with the 77-DX can position the microphone at different angles to modify its frequency response. For example, with the microphone suspended, tilting it on the horizontal axis will cause the ribbon to sag slightly, resulting in a noticeable boost in the lower-midrange frequencies.