enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ISCAR Metalworking - Wikipedia

   en.wikipedia.org/wiki/ISCAR_Metalworking

   ISCAR Ltd. is an Israeli multinational metal cutting tools company affiliated with one of the world's largest metalworking conglomerates, the IMC Group (International Metalworking Companies). ISCAR and the IMC Group were acquired by Warren Buffett 's Berkshire Hathaway in 2006, becoming one of its largest non-insurance companies.

3. International Metalworking Companies - Wikipedia

   en.wikipedia.org/wiki/International_Metalworking...

   IMC International Metalworking Companies B.V., otherwise known as IMC Group, is the holding company of several worldwide manufacturers of metal cutting tools. [citation needed] Together they produce a wide range of carbide inserts, carbide endmills and cutting tools covering all metal cutting applications. The IMC Group is in the automotive ...

4. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   E-clip. Common examples include e-clips (e-rings) and the snap ring (both internal and external) or circlip. These general types of fasteners are sized to provide an interference fit onto (or into, in the case of an internal fastener) a groove or land when in use, such that they must be elastically deformed in order to install or remove them.

5. Undercut (turning) - Wikipedia

   en.wikipedia.org/wiki/Undercut_(turning)

   They are often used at the end of the threaded portion of a shaft or screw to provide clearance for the cutting tool, and also referred to as thread relief in this context. A rule of thumb is that the undercut should be at least 1.5 threads long and the diameter should be at least 0.015 in (0.38 mm) smaller than the minor diameter of the thread ...

6. Groove (engineering) - Wikipedia

   en.wikipedia.org/wiki/Groove_(engineering)

   In manufacturing or mechanical engineering a groove is a long and narrow indentation built into a material, generally for the purpose of allowing another material or part to move within the groove and be guided by it. Examples include:

7. Boring (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Boring_(manufacturing)

   A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.