Search results
Results from the WOW.Com Content Network
A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float. Another common type is a float that raises a rod to actuate a microswitch.
Sump pumps are used where basement flooding may otherwise happen, and to solve dampness where the water table is near or above the foundation of a structure. Sump pumps send water away from a location to any place where it is no longer problematic, such as a municipal storm drain, a dry well, or simply an open-air site downhill from the building (sometimes called "pumping to daylight").
The polished rod is connected to a long string of rods called sucker rods, which run through the tubing to the down-hole pump, usually positioned near the bottom of the well. Picture of a pump jack used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface.
Franklin Electric Co., Inc. is a manufacturer and distributor of products and systems focused on the movement and management of water and energy. The company offers pumps, motors, drives, and controls for use in a variety of residential, commercial, agricultural, industrial, and municipal applications.
In a dry-sump system, the oil still falls to the base of the engine, but into a much shallower sump, where one or more scavenge pumps draw it away and transfer it to a (usually external) reservoir, where it is both cooled and de-aerated before being recirculated through the engine by a pressure pump. The sump in a dry-sump system is not ...
The line of sucker rods is represented in this diagram by the solid black line in the center of the well. A sucker rod is a steel rod, typically between 7 and 9 metres (25 and 30 ft) in length, and threaded at both ends, used in the oil industry to join together the surface and downhole components of a reciprocating piston pump installed in an oil well.
In most production automobiles and motorcycles, which use a wet sump system, the oil is collected in a 3 to 10 litres (0.66 to 2.20 imp gal; 0.79 to 2.64 US gal) capacity pan at the base of the engine, known as the sump or oil pan, where it is pumped back up to the bearings by the internal oil pump. A wet sump offers the advantage of a simple ...
[c] These are supplementary pumps and do not replace the main, mechanical, oil pump. Electric pump as a main engine pump again will require big electric motors and it may be simply cheaper to drive directly from the engine. For e.g. BMW S65 engine's oil pump delivers ca. 45 LPM (Litres Per Minute) of oil at 5.5 bar pressure. [5]