Search results
Results from the WOW.Com Content Network
While a symmetric spinnaker is flown with a "guy" and a "sheet", an asymmetric spinnaker is flown with a tackline and a "sheet." The tack attaches to the bow or (often retractable) bowsprit, and the two sheets attach to the clew. The head of the sail is attached to the spinnaker halyard, which is used to raise the sail.
The jib sheet attaches to the clew of the jib, and controls it. The jib has a sheet on each side, only one of which (the leeward one) will be in use at one time. The spinnaker sheet attaches to the clew(s) of the spinnaker, if carried. A symmetrical spinnaker has two sheets, an "active" one and a "lazy" one, in the same way as a jib, but they ...
To prepare the bed for sleeping, the cowboy laid it out with the tarp folded roughly in half at the middle, creating a near-square 6–7 ft. wide and 7–9 ft. long, and centered his bedding between the two long edges, with the top side of the tarp (2.5 to 3 ft. longer than the bottom, so it could be pulled completely over his head if desired ...
Since there is no spinnaker pole, there is no longer need for a pole topping lift or a pole downhaul. Like a jib, the asymmetric has two sheets and no "guy". The asymmetric is simpler to gybe than a conventional spinnaker since it only requires releasing a sheet and pulling in the other one, passing the sail in front of the forestay. An ...
Because a spinnaker has two clews, there is always a second line identical to the afterguy attached to the leeward clew of the spinnaker. This is called the sheet and serves a slightly different function. When the boat jibes, the spinnaker pole will be moved from one side of the boat to the other, causing the sheet to become the guy and vice versa.
The spinnaker pole is rigged to run from the base of the mast, [1] where there is a special fitting for attaching one end of the pole, out to windward over the side of the boat. There, one of the control lines of whichever sail it is to be used with is run through a fitting on the other end of the spinnaker pole. This allows for more precise ...
However, under sail on a given tack, the corner to which the spinnaker sheet is attached is called the clew, and the corner attached to the spinnaker pole is referred to as the tack. [ 20 ] Tack – The tack is the corner on a fore-and-aft sail where the luff and foot connect [ 8 ] and, on a mainsail, is located where the boom and mast connect.
A jib, left, compared to a roughly 110% genoa, right. The foretriangle is outlined in red. The term jib is the generic term for any of an assortment of headsails.The term genoa (or genny) refers to a type of jib that is larger than 100% of the foretriangle, which is the triangular area formed by the point at which the stay intersects the mast, and deck or bowsprit, and the line where the mast ...