Search results
Results from the WOW.Com Content Network
Lime render is the first coat of lime "plaster or the like" [1] applied to the external surfaces of traditionally-built stone or brick buildings. It allows the building to 'breathe' – as lime is porous, it allows for the collection and evaporation of moisture .
Lime plaster is a type of plaster composed of sand, water, and lime, usually non-hydraulic hydrated lime (also known as slaked lime, high calcium lime or air lime). Ancient lime plaster often contained horse hair for reinforcement and pozzolan additives to reduce the working time.
Roughcast or pebbledash is a coarse plaster surface used on outside walls that consists of lime and sometimes cement mixed with sand, small gravel and often pebbles or shells. [1] The materials are mixed into a slurry and are then thrown at the working surface with a trowel or scoop.
Cement render or cement plaster is the application of a mortar mix of sand and cement, (optionally lime) and water to brick, concrete, stone, or mud brick. It is often textured, colored, or painted after application. It is generally used on exterior walls but can be used to feature an interior wall. [1]
Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system. EIFS has been in use since the 1960s in North America and was first used on masonry buildings.
This means a roof coating actually becomes the top layer of a composite roof membrane and underlying system. As such, the roof coating is the topmost layer of protection for the membrane, receiving the impact of sunlight (both infrared and ultraviolet (UV)), rain, hail and physical damage. Roof Coatings should not be confused with deck coatings.
One coat work is the coarsest and cheapest class of plastering, and is limited to inferior buildings, such as outhouses, where merely a rough coating is required to keep out the weather and draughts. This is described as render on brickwork, and lath and lay or lath and plaster one coat on studding.
the plaster is applied in one thick coat with a wooden float, and smoothed with the same. before the plaster sets, a flat, smooth, hard stone is used to compress the plaster, then a plastic trowel used for the final polish. it is mechanically polished using stones or abrasives harder than the plaster, providing a smooth, sometimes shiny, finish.