Search results
Results from the WOW.Com Content Network
The USI is a multi-purpose hardware communication module. With appropriate software support, it can be used to implement an SPI, [79] I²C [80] [81] or UART [82] interface. USART peripherals have more features than USI peripherals.
The FT-817 is based on a similar circuit architecture as Yaesu's FT-857 and FT-897, so it is a compromise transceiver and incorporates its features to its low price ($670.- at its 2001 release). [3] The upgraded FT-817(N)D was launched in 2004. The difference between the two models is the addition of 60 meter band coverage in 5 fixed channels ...
The AVR is a modified Harvard architecture machine, where program and data are stored in separate physical memory systems that appear in different address spaces, but having the ability to read data items from program memory using special instructions.
The Orin product line now features SoC and SoM (System-On-Module) based on the core Orin design and scaled for different uses from 60W all the way down to 5W. While less is known about the exact SoC's that are being manufactured, Nvidia has publicly shared detailed technical specifications about the entire Jetson Orin SoM product line.
Front page of a floppy disk controller data sheet (1979) A datasheet, data sheet, or spec sheet is a document that summarizes the performance and other characteristics of a product, machine, component (e.g., an electronic component), material, subsystem (e.g., a power supply), or software in sufficient detail that allows a buyer to understand what the product is and a design engineer to ...
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
Rapid City Communications, founded in April 1996, [12] developed the F1200 routing switch in 1997. [13] The main advantage of this product over others at the time was the ASICs on the modules allows the switching and routing of packets to take place on the ASIC chips within each module, instead of having to forward them to a central processing unit (CPU).
These times are specified in the data sheet for the device, and are typically between a few nanoseconds and a few hundred picoseconds for modern devices. Depending upon the flip-flop's internal organization, it is possible to build a device with a zero (or even negative) setup or hold time requirement but not both simultaneously.