Search results
Results from the WOW.Com Content Network
In physical chemistry, Henry's law is a gas law that states that the amount of dissolved gas in a liquid is directly proportional at equilibrium to its partial pressure above the liquid. The proportionality factor is called Henry's law constant. It was formulated by the English chemist William Henry, who studied the topic in the early 19th ...
The gas constant occurs in the ideal gas law: = = where P is the absolute pressure, V is the volume of gas, n is the amount of substance, m is the mass, and T is the thermodynamic temperature. R specific is the mass-specific gas constant. The gas constant is expressed in the same unit as molar heat.
The form of the equilibrium constant shows that the concentration of a solute gas in a solution is directly proportional to the partial pressure of that gas above the solution. This statement is known as Henry's law and the equilibrium constant is quite often referred to as the Henry's law constant. [10] [11] [12]
where P is the pressure, V is volume, n is the number of moles, R is the universal gas constant and T is the absolute temperature. The proportionality constant, now named R, is the universal gas constant with a value of 8.3144598 (kPa∙L)/(mol∙K). An equivalent formulation of this law is: =
Where: R is the Ideal gas constant (8.314 Pa·m 3 /mol·K); T is the absolute temperature (K); H is the Henry's law constant for the target chemical (Pa/m 3 mol); K ow is the octanol-water partition coefficient for the target chemical (dimensionless ratio); P s is the vapor pressure of the target chemical (Pa); and v is the molar volume of the ...
By contrast, each solute molecule is surrounded by solvent molecules, so it obeys a different law known as Henry's law. [9]: 171 By Henry's law, the fugacity of the solute is proportional to its concentration. The constant of proportionality (a measured Henry's constant) depends on whether the concentration is represented by the mole fraction ...
The following table lists the Van der Waals constants (from the Van der Waals equation) for a number of common gases and volatile liquids. [ 1 ] To convert from L 2 b a r / m o l 2 {\displaystyle \mathrm {L^{2}bar/mol^{2}} } to L 2 k P a / m o l 2 {\displaystyle \mathrm {L^{2}kPa/mol^{2}} } , multiply by 100.
The bar is a metric unit of pressure defined as 100,000 Pa (100 kPa), though not part of the International System of Units (SI). A pressure of 1 bar is slightly less than the current average atmospheric pressure on Earth at sea level (approximately 1.013 bar).