Search results
Results from the WOW.Com Content Network
Three RCA connectors - yellow for composite video, and white and red for stereo audio RCA connector: Widely used in consumer electronics for audio and video. A single connector must be used for each signal. SCART: Consumer electronics, mostly in Europe. Carries analog stereo sound, along with composite video and/or RGB video.
Board to board connectors – e.g. card-edge connectors or FPGA mezzanine connectors; Twist-on wire connectors (e.g. wire nuts) – used in low-voltage power circuits for wires up to about 10 AWG; Wire wrapping – used in older circuit boards
Black, Red and Blue are used for hot wires and White is used as the neutral wire in a 120/208 V circuit. Brown, Orange and Yellow are used as hot wires and gray is used as the neutral wire in a 277/480 V. For grounding, regardless of the voltage, Green (or a bare wire) is used.
In the male connector, this pin numbering corresponds with the cable's wire-and-solder side. The Video Graphics Array ( VGA ) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors ...
Video In Video Out, usually seen as the acronym VIVO (commonly pronounced vee-voh), is a graphics card port which enables some video cards to have bidirectional (input and output) video transfer through a Mini-DIN, usually of the 9-pin variety, and a specialised splitter cable (which can sometimes also transfer sound).
The connector first appeared in the Nvidia RTX 40 GPUs. [5] [6] The prior Nvidia RTX 30 series introduced a similar, proprietary connector in the "Founder's Edition" cards, which also uses an arrangement of twelve pins for power, but did not have the sense pins, except for the connector on the founders edition RTX 3090 Ti (though not present on the adapter supplied with those cards.) [7]
The ATX connector provides multiple wires and power connections for the 3.3 V supply, because it is most sensitive to voltage drop in the supply connections. Another ATX addition was the +5 V SB (standby) rail for providing a small amount of standby power , even when the computer was nominally "off".
1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated: